Safety / use / maintenance and cleaning / service – Livarno Z30957 User Manual
Page 3

5
GB
Safety / Use / Maintenance and cleaning / Service
Avoid the danger of
death from electric shock!
Before use, ensure that the mains voltage
available is the same as the required operating
voltage for the device (230 Volt∼).
Before connecting the device to the mains you
should always check the device and the mains
lead for any damage. A damaged device
represents the danger of death from electric shock.
The supply cord of the lamp cannot be replaced.
If the cord is damaged the appliance should
be scrapped.
Do not use the device if you find any damage.
Never open any of the electrical equipment
or insert any objects into it. Such interventions
represent the danger of death from electric shock.
It is essential that the device does not come
into contact with water or other liquids.
Never touch the mains plug with damp or wet
hands.
Protect the mains lead against sharp edges,
mechanical stresses and hot surfaces.
Never use the device in the immediate vicinity
of a bathtub, shower or swimming pool.
If the lamp is not to be used for an extended
period (e.g. during your holidays), pull the mains
plug out of the mains socket.
This lamp is only intended for use
indoors.
0.5 m
FIRE HAZARD! Fit the light so that
it is at least 0.5 m away from the
material illuminated. Fire can result
from the development of too much heat.
Use
Use the lamp as shown in Fig. A.
Replacing a bulb
Switch off the lamp using the ON / OFF switch.
Pull the mains plug out of the mains socket and
allow the lamp to cool down.
Screw the old bulb out of the socket.
Screw a bulb of the same type into the fitting
of the lamp. Ensure that the bulb is securely
and firmly seated.
Maintenance and cleaning
CAUTION! DANGER OF ELECTRIC
SHOCK! For electrical safety reasons do not
clean the lamp with water or other liquids and
never immerse it in water.
Do not use any solvents, petrol or similar. This
would cause damage to the light.
Pull the mains plug out of the mains socket and
allow the lamp to cool down.
Service
GB
Service Great Britain
Tel.:
0871 5000 720
(0,10 GBP/Min.)
e-mail: [email protected]
IAN 66258
IE
Service Ireland
Tel:
1890 930 034
(0,08 EUR/Min. (peak)
0,06 EUR/Min. (off peak))
e-mail: [email protected]
IAN 66258
66258_liv_Tischleuchte_Content_GB-SE-HU-HR-PL-DE.indd 5
08.06.11 17:03