Livarno LLR 58 A1 - Manual (Page 15)

15
 Insert one of the fixing screws (4) from
below through one of the two holes.
 Hold the tube holder (7) with the
perforated underside against the
screw. Tighten the screw in the tube
holder with a suitable screwdriver.
 Turn the second fixing screw (4)
through the other hole in the stand and
also in the tube holder.
 Position the assembled stand upright
and place the light with the mains lead
downwards in the stand. There is a
recess specially for the mains lead in
the tube holder. Thread the mains lead
through this recess until the light is
fixed firmly in the light stand.
Take care as the light will become
warm when it is in use.
Turning on / off
Use the on / off switch (8) to turn the light
on and off.
The light is equipped with a quick
start so that it comes on directly after
being switched on. It does not flicker
like conventional fluorescent tubes.
Cleaning
Allow the light to cool down before
cleaning.
To clean the light use a dry cloth and never
use any solvent or cleaner that would
corrode the material. Ensure that no liquid
enters the housing. Use a damp cloth for
more stubborn dirt.
Disposal of old devices
When this symbol appears on a
product, this indicates that the
product is subject to the European
Directive 2002/96/EC. All old
electric and electronic devices must be
separated from normal household waste
and disposed of at designated state
facilities. Disposal of old devices in this
manner will prevent harm to the
environment and human health hazards.
For further information regarding disposal
of old devices in accordance with the
Directive contact your local government
office or the retailer where you purchased
this product.
Declaration of Conformity
We, Targa GmbH, Lange
Wende 41, 59494 Soest,
declare that this product
conforms to the full extent with the basic
requirements and other required provisions
of the EMC Directive 2004/108/EC.