Livarno 54322 - Manual (Page 8)

8 GB/IE
Start-up / Troubleshooting / Maintenance/ Cleaning Functionality / Start-up
Functionality
The solar module built into this product converts
sunlight into electricity and stores it in the recharge-
able NiMH battery. Switches on the light as it
begins to get dark.
The in-built light-emitting diodes are a very long-life
and energy-saving light source.
The light duration depends on the amount of sun-
light, the angle of light on the solar panel and the
temperature (the battery capacity is temperature-
dependent). A vertical angle of light at tempera-
tures above the freezing point is ideal.
The battery does not achieve maximum capacity
until after several charge and discharge cycles.
Start-up
Assembling the light
Remove the individual parts from the packaging
and assemble the solar light as shown in figures
A1–A3. There are two options for doing so: the
spacer tube
3 will give the solar light a height of
approx. 40 cm (see Fig. A2), using the spacer tube
2 it will have a height of approx. 27 cm (see
Fig. A3).
Insert the selected spacer tube 2 or 3 into
the designated opening on the solar module
5 (see Fig. A1).
Then insert the ground stake 1 into the bot-
tom of the spacer tube 2 or 3 (see Fig. A1).
Installing the light
The solar light can be installed without a power
source. Only use the solar light with the included
ground stake
1 . Push the assembled solar light far
enough into the ground (lawn, flower bed) so it is
stable.
Since the light relies on sunlight, consider and ob-
serve the following points prior to installation:
Select a location where the solar module 5 is
exposed to direct sunlight during the day.
Position the solar light so the solar module 5
is not covered or in the shade (trees, roof
ridge, etc.).
Be sure the solar module 5 is not impacted
by another light source, e.g. yard or street light-
ing, as this will prevent the light from switching
on at twilight. Remember many light sources
will only switch on due to the time or movement
during the night.
Prior to initial use
The solar light features a twilight sensor and an
On/Off switch. When fully charged the light on
time is approx. 6 to 8 hours.
Unscrew the sphere 4 from the solar module 5
counter-clockwise. Set the On/Off switch g to
ON before using it for the first time.
Screw the sphere 4 clockwise all the way into
the solar module 5 and place the solar light
in the sun.
Light functions
Switch g set to ON - the solar light will auto-
matically switch on at twilight. At dawn the
light will automatically switch off.
Switch g set to OFF - the solar light is perma-
nently switched off.
Switch h set to RGB - the solar light will switch
between the colours RED - GREEN - BLUE with
a flowing colour transition and repeat the
cycle. The entire process take approx 55 sec.
Switch h set to RGB OFF - the solar light
will continuously light up in the current colour
selection.
Replacing the battery
The rechargeable battery is designed for pro-
longed operation. However, after a long time of
use if may need to be replaced. Rechargeable bat-
teries are subject to natural wear and the output