Livarno Z30697 - Manual (Page 12)

12 GB/IE
12 GB/IE
Installation Installation
light off by pressing the ON/OFF
switch
10 again.
note: Please bear in mind that the
light will only switch itself on or off
under twilight conditions automati-
cally if the light is switched on.
11. Insert the light into the substrate.
Your light is now ready for operation.
Q
Installing the floor light
in concrete substrates
note: A quantity of mixed concrete is
required for this stage of the installation.
Follow the manufacturer’s instructions.
1. Choose a suitable location for the
floor light.
2. Drill a hole in the concrete sub-
strate.
note: Ensure that the depth of the
hole corresponds with the depth of
the floor insert 12 with concrete
socket including the floor light.
Bear in mind that the decorative
collar
2 must be placed on top of
the substrate surface later
(see Fig. J).
3. Pour a little mixed concrete into the
predrilled hole.
4. Place the floor insert 12 in the hole
and let the concrete harden. Follow
the manufacturer’s instructions (see
Fig. G).
5. Follow steps 3 to 7 of the section
on “Installing the floor light in soil
or wooden substrates”.
6. Press the ON / OFF button 10 to
switch on the light.
7. Insert the light body 5 into the
floor insert 12 (see Fig. H).
8. Fix the light body 5 and floor in-
sert 12 together with the screws 13
(see Fig. H).
9. Follow steps 8 and 9 of the section