Livarno 1321-012L or 1322-022L - Manual (Page 14)

14 GB
... / Maintenance and Cleaning / Disposal / Information Safety / Start-up
To prevent hazards, a damaged flexible outer
lead on this lamp must be replaced by the man-
ufacturer, its service representative or an equally
qualified professional!
Before use, verify the available mains voltage
corresponds with the operating voltage of the
lamp (230–240 V∼).
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Always unplug from the mains before assembling,
disassembling, cleaning, or if the lamp will not
be used for extended periods.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
The illuminant is not replaceable.
This light is not suitable for dimmer or electronic
switches.
Prevent fire and
injury hazards
RISK OF INJURY! Check every illuminant for
damage immediately upon unpacking. Do not
install the light if the illuminants are defective.
In this case contact the service centre for a re-
placement.
Do not look directly into the light source (light
bulb, LED etc.).
Do not leave the light or packaging material ly-
ing unattended. Plastic film or bags, plastic parts
etc. can turn into dangerous toys for children.
Do not cover the lamp or the mains plug with
objects. Excessive heat can result in a fire.
Never leave the lamp unattended whilst in use.
Safe working
Mount the light so that it is protected from mois-
ture and dirt.
Carefully prepare for assembly and allow your-
self adequate time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never assemble the lamp if you are unfocused
or feel unwell.
Start-up
Mounting the light
Note: When assembling the stand tube 4 be sure
not to damage the mains lead 5 inside the lamp.
Unfold the floor lamp.
Insert the upper stand tube section 4a into the
lower stand tube section 4b .
Carefully pull the mains cable 5 out of the
stand tube 4 .
Place the chrome plating 8 on the base 6 .
Put the stand tube 4 through the chrome plat-
ing 8 into the base 6 and fasten the stand
tube 4 by turning clockwise.
Place the plain washer 9 and the nut 10 on
the thread and use the tool 11 to screw it tight.
Model 1322-022L: Screw the adjustment
lever
7 onto the reflector 1 . You will need a
small screwdriver to do this.
Plug the mains plug into a socket that has been
professionally installed.
Your light is now ready to use.
Switching the lamp on / off
Switch the lamp on or off using the ON/OFF
switch
12 .
Adjusting the reflector
Note: Only adjust the reflector 1 with the light
switched off.
Allow the lamp to cool off completely.
Turn the lamp arm 2 to the desired position.
Note: Re-tighten the locking lever 3 if the
lamp arm 2 changes in position.