Livarno 2973-010E - Manual (Page 18)

18 GB
Safety / Assembly / Operation Introduction / Safety
Halogen Clip Light
Q Introduction
We congratulate you on the purchase of
your new device. You have chosen a high
quality product. Please read carefully
and completely through these operating instructions.
Fold out the page with the illustrations. These instruc-
tions form part of the product and contain important
information about bringing the product into use and
its handling. Always observe all the safety advice.
Check that the correct mains voltage is available
and that all the parts have been properly assembled
before bringing into use. Should you have any
questions or be uncertain as to how to operate the
device, please get in touch with your dealer or ser-
vice point. Please keep these instructions in a safe
place and hand them on to a third party if necessary.
Q
Proper use
This light is designed only for use indoors, in dry
and enclosed rooms. The light can be attached to
any surface classified as normally inflammable,
except pipes. Any use other than that described
above or modification to the lamp is not permitted
and may lead to damage to people or property.
Moreover, there is the risk of injury or loss of life and
that the lamp may develop technical faults such as
short circuit or fire or give an electric shock.
This lamp is intended for use only in a domestic
environment.
Q Included items
Check that all the items and accessories are pre-
sent and that the lamp is in perfect condition
immediately after unpacking.
1 Halogen Clip Lamp (1-light spotlight)
1 Bulb GU 10, 35 W
1 Glass shade
1 Operating instructions
Q Description of parts
1 Spotlight
2 Bulb
3 Glass shade (model 2973)
4 ON / OFF in-line switch
5 Mains lead with plug
6 Chrome ring (model 2972)
Q
technical information
Operational voltage: 230–240 V~, 50 - 60 Hz
Bulb: 35 W
Maximum nominal
output:
1 x 35 W
Protection category: II /
Model:
2973-010L (Spot head blue)
2973-016L (Spot head white)
2972-014L (Spot head titanium)
2972-016L (Spot head white)
Q
Safety
Safety advice
The right to claim under the guarantee shall be
rendered invalid in respect of damage caused by
the non-observance of these operating instructions!
No liability is accepted for consequent damage!
No liability is accepted for damage to property
or persons caused by improper handling or non-
observance of the safety advice!
to avoid danger to life
from electric shock
Every time before connecting the lamp the mains,
check it and the mains lead for damage. Never
use your light if you find it is damaged in any way.
CAUtIon! A damaged mains lead presents
a serious danger to life from electric shock.
In the event of damage, repairs or other problems