Before use, Using the led magnifier light, Adjusting the led magnifier light – Livarno 101449-14-01-BS User Manual

Page 7: Using the magnifier

GB/IE

CAUTION! RISK OF FIRE! Never expose the
magnifier to direct sunlight or other light sources.
Never leave an open magnifier unattended. Doing

so presents a fire hazard due to bundled light rays and con-
centrated heat.

Before use

Insert the screw clamp into the bracket

(Fig. A). Secure the

screw clamp into the bracket using the lock screw

(Fig. B).

Now place the screw clamp onto a table top ≤ 6 cm in thickness
and secure the screw clamp by turning the screw clockwise
(Fig. C).

Insert the articulated arm

into the round hole on the bracket

and secure by tightening the wing bolt

clockwise (Fig. D).

Verify the articulated arm is firmly tightened in the bracket.

Using the LED magnifier light

Plug the mains plug of the light into a properly installed socket.
Move the ON / OFF switch

into the

I position to switch the

light on.

Move the ON / OFF switch into the

0 position to switch the

light off.

Adjusting the LED magnifier light

Never use force when adjusting the light.
The light can be adjusted in different ways:

· The lamp head is pivot-mounted inside the ball joint

(Fig. F).

· After loosening the lock screw

you can adjust the lamp

head up or down. Tighten the lock screw after adjusting the
light to the desired position.

· The individual parts of the articulated arm

can be moved

by the joints

Using the magnifier

Lift the cover

to use the magnifier.

Focus the object you wish to view by changing the distance to the

object and the distance between your eyes and the magnifier.

101449_livx_LED-Lupenleuchte_Content_BS_IE.indd 7

06.08.14 16:08