Livarno 100654-14-01, 100654-14-02 - Manual (Page 6)

6 GB
Fit the light in such a way to en-
sure it is protected from damp
and dirt.
Q Before installation
Important: The electrical connection must be made
by a qualified electrician or a person authorised to
perform electrical installations. This person must be
familiar with the properties of the light and all con-
nection regulations.
Q Installation
Note: You will need an electric drill to install the light.
CAUTION! RISK OF INJURY! Please read
the operating instructions for your drill.
1. Remove the plastic dome 4 from the light
body 1 . Squeeze the plastic dome 4 side
slightly to remove the dome.
2. Hold the light body 1 on to the wall or ceiling
and mark the positions where the mounting
holes are to be drilled.
CAUTION! Ensure that you do not damage
any electricity cables in the wall or ceiling.
3. Now drill the mounting holes (approx. Ø 8 mm).
4. Insert the dowels
6 into the drilled holes. If
necessary use a hammer to make this easier.
5. Push the mains connecting cable through the
hole in the light body 1 and fix the lamp with
the screws 3 into the dowels 6 .
6. Now connect the mains connection cable to
the terminal block 2 .
Note: Ensure that each wire of the mains
connection cable is correctly connected.
7. Mount the plastic dome 4 back on to the light
body 1 . The plastic hook of the dome must
lock into the notch in the lamp housing.
Q Maintenance and cleaning
DANGER TO LIFE BY ELEC-
TRIC SHOCK! Before carrying out any work on
the light, switch the electricity supply off at the fuse
box or remove the screw-in fuses from the fuse box.
DANGER TO LIFE BY ELEC-
TRIC SHOCK! For electrical safety the light must
never be cleaned with water or other liquids, or
immersed in water.
Q Cleaning
CAUTION! RISK OF BURNS! Switch the
light off. Allow the light to cool down completely
(at least 10 minutes).
Use a dry fluff-free cloth when you are cleaning.
Q Disposal
The packaging is made entirely of
recyclable materials, which you may
dispose of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
Under no circumstances should the
device / article and its bulbs be disposed
of with normal household rubbish.
The device / article and its bulbs should be disposed
of at an officially approved disposal centre or at
your local communal disposal facility.
Observe the applicable regulations. If you are
uncertain of what to do please contact your local
authority’s refuse disposal department.