Livarno 2973-01хE - Manual (Page 7)

7 GB
Never let the lamp come into contact with
water or other liquids.
Never open any electrical fittings such as in-line
switches, transformers etc. or allow any object
to be inserted into them. This sort of interference
can lead to a serious danger to life from
electric shock.
To avoid danger of fire and injury
RISk Of InjuRy! Check every bulb and
lampshade for damage immediately upon un-
packing. Do not fit the light if the bulbs and / or
lampshades are faulty. If they are, contact the
service point for a replacement.
RISk Of InjuRy fROM buRnS! Ensure
the lamp has been switched off and allowed to
cool before you touch it. In this way you will
avoid the danger of burns. Bulbs give off a lot
of heat around the top of the lamp.
Allow the lamp to cool for at least 15 minutes
before replacing a defective bulb.
Replace defective bulbs immediately. Before
replacing the bulb always remove the plug
from the mains socket.
0.3 m
DAngeR Of fIRe! Install the
spotlight so that it is at least 0.3 m
from any illuminated materials.
Never leave the spotlight operating unattended.
Fire can result from the development of too
much heat.
This light is not suitable for use as a night light.
Do not allow the lamp or the packaging materials
to lie around unattended. Plastic film or bags,
Styrofoam etc. can turn into dangerous toys for
children.
Do not attach the lamp to damp or conductive
substrates.
Working safely
Only use 230–240 V bulbs with a GU 10
base and a maximum output of 35 Watts.
Fit the light in such a way to ensure it is
protected from damp and dirt.
Do not attach this spotlight to pipes.
Q Assembly
Q fitting the light
Use a clean, fluff-free cloth when you are fitting
the bulb.
Fit the bulb 2 and the glass shade 3 on to
the spotlight together (see Fig. B). Use a dry, fluff-
free cloth for this. First put the bulb
2 into the
glass shade 3 . Insert the bulb 2 carefully
into the fitting and attach it along with the glass
shade
3 by turning it a ¼ turn clockwise. Now
press the glass shade 3 into the spotlight 1
and lock it in place by turning it a ¼ turn clock-
wise. Check that everything is correctly seated.
Clamp the spotlight on to a suitable object.
note: make sure that the anti-slip rubbers and
the bracket are secure.
Insert the mains plug 5 (attached to the mains
lead) into the mains socket.
Your spotlight is now ready for operation.
Q
Operation
Q
On / Off switch
Flip the ON / OFF in-line switch 4 to turn the
spotlight on or off.
Q
Directing the spotlight
Only change the direction of the spotlight 1
after the light has been switched off.
Allow the lamp to cool down completely.
Turn the spotlight 1 in the desired direction. The
spotlight 1 can be turned to face any direction.
Q Changing the bulbs
CAuTIOn! DAngeR Of eLeCTRIC
SHOCk! First pull the plug
5 attached to the
mains lead out of the mains socket.
Allow the lamp to cool down completely.
Only change the bulb
2 when it has completely
Safety / Assembly / Operation