Livarno LED PARTY LIGHT - Manual

LED PARTY LIGHT
LLPL 27 B1, LLPL 14 A1, LLPL 10 A1 – 07/2014 – V 1.16
Introduction
Thank you for purchasing a LIVARNO LUX product.
Intended use
This LED party light (LLPL 27 B1, LLPL 14 A1 or
LLPL 10 A1) is suitable only for indoor illumination. The LED
party light may only be used privately and not for industrial
or commercial purposes. Any other use is not as intended.
This LED party light is not suitable for general room
illumination in the home.
Supplied items
 LED party light
 These instructions
Technical data
Voltage: 220-240 V
~
50 Hz, 30 mA
Power: 3.3 W
Protection class: II
Rotations: approx. 9 per minute
LEDs: 1 x red, 1 x green, 1 x blue
Beam angle: approx. 140 degrees +/- 5%
Diameter: approx. 80mm
The technical data and design may be changed without
notification.
Non-dimmable
The LED party light bears this symbol which indicates that
the LED party light is non-dimmable and must never be used
with a dimmer.
Safety instructions
Before using the LED party light for the first time, please
read the following instructions and pay attention to all
warnings, even if you are familiar with handling electronic
devices. Store these instructions in a safe place for future
reference. If you sell or pass on the LED party light to
someone else, be sure to always include these instructions
as they are an integral part of the device.
WARNING! This symbol indicates important
information for safe operation of the LED party
light and the safety of the user.
Electrical devices do not belong in the hands of
children. Never allow children to use electrical
devices unsupervised. Children must not play with
the device. Children may not recognise potential
risks. Always keep plastic packaging away from
children. It poses a suffocation risk!
The housing of the LED party light must not be
damaged. There is a risk of an electric shock if the
housing is damaged.
Never open the housing of the LED party light
because it does not contain any parts that require
maintenance. There is a risk of an electric shock if
the housing is open.
Never use such optical instruments as a magnifying
glass to look directly into the light beam. This can
lead to eye injuries. In the event of a suspected eye
injury, consult a doctor.
Installation and use
The circuit must be switched off during the
installation! It poses an electric shock risk!
Disconnect the mains plug of the light if available.
Cord switches do not disconnect from the mains
power supply. They provide no protection against
an electric shock.
 Switch off the circuit prior to installation.
 If present, remove an existing light bulb from the socket.
 Screw the LED party light into the socket.
 Switch on the circuit again to use the LED party light.
Maintenance
The light bulb of the LED party light consists of long-lasting
LEDs. They cannot be replaced and do not require
maintenance.
Cleaning
The LED party light must be switched off before it is
cleaned.
Ensure that no liquid can penetrate the housing.
There is a risk of an electric shock.
To clean the LED party light, use a soft, dry cloth and never
use any solvent or cleaner that would corrode the plastic
materials.