Battery safety instructions, Bringing into use, Inserting / replacing the batteries – Livarno Z29538A /Z29538B User Manual
Page 5: Installing the light
5
GB
Battery Safety Instructions
DANGER TO LIFE! Keep
batteries out of the reach of children. Do not
leave batteries lying around. There is a risk of
children or animals swallowing them. Consult a
doctor immediately if a battery is swallowed.
J
EXPLOSION HAZARD! Never
recharge nonrechargeable batteries,
short-circuit and / or open batteries.
This can cause them to overheat, burn or burst.
Never throw batteries into fire or water. The
batteries may explode.
J
Remove spent batteries from the product
immediately. Otherwise there is an increased
risk of leakage.
J
Always replace all batteries at the same time
and only use batteries of the same type.
J
Do not use different types of batteries or mix
used and new batteries together.
J
Check regularly that the batteries are not leaking.
J
Leaked or damaged batteries can
cause chemical burns if they come into
contact with the skin; in such cases
you must wear suitable protective gloves!
J
Remove the batteries from the product if it is not
in use for any length of time.
J
Make sure that the polarity is correct when you
insert the batteries! This is indicated in the battery
compartment. The batteries can otherwise explode.
J
Remove used batteries from the device. Very old
or used batteries may leak. The chemical fluid
can damage the product.
Q
Bringing into use
Q
Inserting / replacing the batteries
Note: Remove the insulating strips before using the
product for the first time.
Note: Switch the product off before you insert or
remove the batteries.
j
Turn the battery compartment cover
3
anticlock-
wise and take it off the battery compartment
2
(see Fig. A).
j
Insert the (new) batteries into the battery
compartment.
Note: Make sure you fit the batteries the right
way round (polarity). The correct polarity is
shown inside the battery compartment.
j
Put the battery compartment cover back in
place on the battery compartment and turn it
clockwise to tighten it (see Fig. B).
Q
Installing the light
j
Pull off the protective film from the self-adhesive
pad
4
of the battery compartment cover
3
(see Fig. C).