Livarno Z31390 - Manual (Page 13)

13 GB
Preparing for use
Installing the light
Install the light in accordance with Figures A, D, E:
1. Rotate the solar cell housing
1 anticlockwise
out of the lamp shade 2 (see Fig. A).
2. Move the ON / OFF switch 5 into the ON
position to switch the light on.
3. Insert the solar cell housing 1 into the lamp
shade 2 and tighten by turning it clockwise.
4. Place the light on to the pole 3 .
5. Take out the ground stake 4 from the pole 3
and insert it into the pole 3 with the tip facing
downwards (see Fig. D).
6. Your solar lamp is ready for use (see Fig. E).
Setting up the light
Insert the assembled solar light far enough
into the ground (lawn, flower bed) for it to be
stable.
Make sure you keep proper footing and bal-
ance at all times. Do not use any force when
assembling or setting-up the product, e.g.