Livarno 104000-14-01-BS - Manual (Page 9)

9 GB/IE
Shortening the
LED strip
The LED strip 1 may be trimmed
to size. It can be cut with scissors
at the marked position, as shown
in Fig. B. The trimmed sections
can then be connected.
DAngER
To LIfE BY ELECTRIC ShoCk!
Before performing any work, first
disconnect the product from the
mains power. To do so, unplug
the power supply
3 from the mains.
Connect as described below:
Remove the protective film
from the double-sided adhe-
sive strip at the ends of the
LED strip sections being
connected.
Then firmly press the end of
the one LED strip onto the
pins on the connector
2 so
they pierce the strip conduc-
tor of the LED strip.
Then push a plastic clip 4
onto this new connection
from the top (Fig. B).
note: Be sure the plastic
clips lock in to establish a
secure connection.
Repeat this process to estab-
lish a contact for the other
end of the connector.
note: Unlike the LED strip,
the connector can be moved
in any direction.
The product
has delicate solder points.
Do not route the LED strip
around corners and do not
kink. The solder points may
otherwise be damaged, dis-
rupting the functionality of
the LED strip.
Connect the power supply
with the LED strip (Fig. A).
Plug the product into a socket
to switch it on.
Be sure the power supply is
always accessible.
Cleaning and Care
Only clean with a dry
lint-free cloth.