Livarno LED PLUG-IN LIGHT - Manual (Page 5)

5 GB/IE
Introduction / Safety
LED Plug-in light
Q
Introduction
Congratulations on your new product.
You have selected a high quality product.
Please read carefully and completely
through these operating instructions. Fold out the
page with the illustrations. These instructions form
part of the product and contain important informa-
tion about bringing the product into use and its han-
dling. Always observe all the safety advice. Check
that the correct mains voltage is available and that
all the parts have been properly assembled before
bringing into use. Should you have any questions
or be uncertain as to how to operate the device,
please get in touch with your dealer or service point.
Please keep these instructions in a safe place and
hand them on to a third party if necessary.
Q
Proper use
This light is suitable only for interior use, in dry and
enclosed spaces. This article is solely to be used as
a reading lamp. This article is a wall or reading
light. Do not use it as a nightlight. This lamp is in-
tended for use only in a domestic environment.
Q
Description of parts
1 Lamp glass
2 Lamp pin
3 Flexible lamp arm
4 ON / OFF switch with a stepless dimmer switch
5 Mains plug
Q
Technical information
Operational voltage: 230 - 240 V ∼ 50 Hz
Bulb: 1x LED 3 W
(LED not replaceable)
Nominal output of lamp: maximum 4.7 W
Protection category:
II /
Q
Included items
Check that all the items and accessories are present
and that the lamp is in perfect condition immediately
after unpacking.
1 LED Plug-in light, model 2917-012E or
2918-012E
1 LED light bulb, 3 W (already installed)
1 Set of instructions
Q
Safety
Safety advice
The right to claim under the guarantee shall be
rendered invalid in respect of damage caused by
the non-observance of these operating instructions.
No liability is accepted for consequent damage.
No liability is accepted for damage to property or
persons caused by improper handling or non-ob-
servance of the safety advice.
To avoid danger to life from
electric shock
Every time before connecting the lamp the mains,
check it and the mains lead for damage. Never
use your light if you find it is damaged in any
way.
CAUTION! A damaged light bulb means your
life is at risk from electric shock. If there is any
damage, repairs to be carried out or other
problems related to the light bulb, please contact
the service centre or a qualified electrician.
Before assembly, ensure that the mains voltage
available corresponds to the operating voltage
necessary of the light (230 - 240 V ∼ 50 Hz).
Never let the lamp come into contact with water
or other liquids.
Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing can
lead to a serious danger to life from electric
shock.