Livarno Z31240 - Manual (Page 25)

25 GB/MT
Failure to follow safety instructions may drain batteries
beyond their end voltage. This will result in a risk of leaks.
If the batteries leaked inside your product, immediately
remove batteries to prevent product damage!
Do not dispose of batteries in your regular household
waste!
The law mandates every consumer to properly dispose
of batteries.
Safety instructions for lamps
LED cannot be replaced.
Switch off the light before putting the product down.
Use
Inserting / replacing batteries
(see illustration)
This product features two lamps with one battery holder
each. Batteries are inserted / replaced identical on both
sides.
Remove the insulating stripes from the battery com-
partment before first use.
Hold on to the lamp neck 3 and unscrew the lamp
head 1 counter-clockwise .
Now remove the battery holder 2 .
Insert 3 type AAA, 1.5 V batteries into the battery
as indicated.
Note: The negative battery pole (flat end) is inserted
on the spring end of the battery holder.
Now insert the battery holder into the torch in the
direction of the arrow (marking on battery holder)
and tightly screw the lamp head
clockwise onto
the lamp neck. The lamp will now light up.
Switching torch on / off
To turn the respective lamp head on / off turn it 1
clockwise / counter-clockwise approximately one rotation.