Livarno Z31346-BS - Manual (Page 6)

6 GB
Before charging, switch the torch 1 off (press ON / OFF switch 2 ).
Plug the male connector of the mains adapter 4 or of the car adapter 5 into
the female connector 8 .
note: When charging from a cigarette lighter socket, the adapter must al-
ways be fully inserted into the cigarette lighter socket of the vehicle. Otherwise
there is the danger of fire through overheating.
Insert the mains adapter into a mains socket or insert the car adapter into the
cigarette lighter socket in your vehicle.
note: The product is fitted with an overcharge protection circuit. Despite this,
you should disconnect the LED inspection lamp from the power supply after the
charging process is complete.
note: During charging, the charge indicator LED 7 lights up red. When
charging is complete, the charge indicator LED lights up green. When the
charge indicator LED is green, pull the mains adapter out of the socket or the
car adapter from the cigarette lighter socket. Disconnect the adapter from the
LED inspection light to prevent the batteries from discharging.
Q
Use
CAUTiOn – riSK OF ACCiDEnT! If at all possible, do not use the LED
work lamp in a moving vehicle. If the LED work lamp is used in a vehicle, it must not
be allowed to endanger the safety of the driver or passengers. Always store and
secure the LED work lamp in such a way that there is no risk of injury from or dam-
age to the product, even during full braking.
note: The LED inspection light
6 features a magnetic foot 3 . Ensure the metallic
surface is sufficiently magnetisable to carry the weight of the light, before you use
the magnetic foot.
Using the LED inspection light without
a power connection
Fully charge the LED inspection light 6 as described in the section “Charging
the LED work lamp“.
Press the ON / OFF switch 2 to switch the torch 1 on or off.
To switch on the LED inspection light, pull it carefully out of the lamp body,
using the handle
9 .
To switch off the LED inspection light, push the inspection light and the lamp
body back together again, using the handle (see Fig.A).
Q
Troubleshooting
Fault Possible causes and cures
No functions - Mains adapter 4 or car adapter 5 is not fully
inserted.
Indicator LED 7
does not illuminate
When connected to a cigarette lighter socket:
- Is the cigarette lighter socket supplied with power?
Some cigarette lighter sockets only supply power with
the ignition switched on.
- Check the fuse in the vehicle.
Charging takes a very
long time When connected to a cigarette lighter socket:
- Vehicle battery too weak?
Q
Maintenance and cleaning
The product requires no maintenance. The LEDs cannot be replaced.
J Switch off and disconnect the product from the power supply before you clean it.
J Never immerse the product in water or other liquids.
J Do not use corrosive cleaning agents.