Safety / bringing into use, Bringing into use – Livarno Z31303C-BS/Z31303D-BS User Manual
Page 7

7
GB
Safety / Bringing into use
mains you should always check the
device and the mains lead for any
damage. A damaged device repre-
sents the danger of death from
electric shock.
J
Do not use the device if you find any
damage.
J
Please consult a specialist electrician
if you discover any damage or prob-
lems with the device, or for the per-
formance of repairs to the device.
J
Never open any of the electrical
equipment or insert any objects into
it. Such interventions represent the
danger of death from electric shock.
J
It is essential that the device does
not come into contact with water or
other liquids.
J
Protect the power supply cable
4
from sharp edges, mechanical strain
and hot surfaces.
J
Never use the device in the immedi-
ate vicinity of a bathtub, shower or
swimming pool.
J
Do not look directly into the light or
its reflection. Do not aim the light di-
rectly at people. This could produce
glare, leading to accidents.
J
If direct or reflected light strikes your
eyes, close them and move your
head immediately out of the light.
J
Operate the lamp only with supplied
mains adapter (LPS03-120-0100-2W).
Please note that any damage caused
through the use of a different adapt-
er is excluded from the warranty.
J
Never touch the mains adapter
6
with moist or wet hands.
J
If the lamp is not to be used for an
extended period, e.g. while you
are away on holiday, then the mains
adapter
6
must be pulled out of
the mains socket.
J
The bulb becomes hot during oper-
ation. Allow the lamp and bulb to
cool before you touch them.
J
The LEDs cannot be replaced.
Q
Bringing into use
j
Never direct the LED light beam on
to reflective surfaces or at people
or animals. Failure to observe this
advice may result in eye injury and /
or loss of sight to people or animals.
Even a weak LED light beam can
cause eye damage.
j
Place the lamp down with its base
2
supported on a flat and horizontal
surface.
j
Connect the mains connector
5
to
the mains adapter
6
.
94316_C-D_LED-Tischleuchte_Content_PL_HU_SI_CZ_SK.indd 7
23.07.13 13:26