Livarno Z30802A-BS Z30802B-BS - Manual (Page 6)

6 GB/IE/CY
what you are doing. Always proceed with
caution and do not assemble the lamp if you
cannot concentrate or feel unwell.
Q Preparation
Q Required tools and materials
The tools and materials mentioned are not included
in the delivery. The details and values given are
non-binding and for guidance only. The nature of
the material depends on the individual circumstanc-
es on site.
- Pencil / Marking tool
- Screwdriver
- Electric drill
- Drill bit
- Spirit level
Q
Preparations for use
Q Mounting the light
1. Measure up the wall or mounting surface for
drilling the holes. Use a spirit level to improve
accuracy.
2. Mark the two mounting holes a distance of
approx. 41 cm apart.
3. Now drill the mounting hole (ø 6 mm). Make
sure that you do not damage any electrical
cables during this operation.
4. Insert the supplied dowels into the drilled holes.
Insert the supplied screws into the dowels and
tighten them.
5. Attach the light using the appropriate mounting
holes 4 or 8 to the screws.
6. Insert the light connector plug of the power supply
cable 12 into the light connector socket 1 .
7. Insert the mains plug of the power supply
cable 12 into a convenient mains socket. Your
light is now ready for operation.
Q Connecting several
lights together
CaUTIOn! Make sure that all under-cabinet lights
are linked together by means of the connecting
cables
7 before inserting the mains plug of the
power supply cable 12 into the socket.
note: Make sure that you only connect a maximum
of 10 linked-up under-cabinet lights of the same
type to one socket.
1. Install up to 10 lights of the same model next
to each other. To do so, follow steps 1 – 5 of
the section called “Mounting the light”.
note: Make sure that the distance between
the lights is not more than 24 cm.
2. Remove the protective head guard 6 by
unscrewing the screw.
3. Insert the connecting cable 7 into the con-
necting socket 5 of the light.
4. Insert the second connection of the connecting
cable 7 into the socket 1 of the other light.
5. Insert the connection of the power supply
cable 12 into the socket 1 of the first light.
6. Insert the the mains plug of the power supply
cable 12 into the socket. Your light is now
ready to use.
Q Switching On / Off
j Switch the ON / OFF switch 2 to turn the light
on or off.
Q Directing the light
j Never change the direction of the light while it
is switched on.
CaUTIOn! DangER OF bURnS! Do not
touch bulb components or bulbs as they can
reach temperatures higher than 90 °C during
operation.
j Allow the light to cool down completely.
j Turn the strip light 9 into the desired direction.
The strip light can pivot through approx. 80°
when mounted under a cabinet (mounting