Electrolux TRILOBITE 8228226-02 User Manual
Page 9
31
30
Emptying and Cleaning the Dust Collector
Cleaning the Roller
1.
Press the button on the rear
side of Trilobite, and ...
2.
... lift off the lid.
3.
Take out the dust collector.
4.
Remove the grille with the
opening facing up.
5.
Empty the collector (prefera-
bly in a plastic bag fit snugly
around the unit).
NOTE! Do not knock the
collector against hard
surfaces to empty it.
6.
Insert a new filter and
replace the grille.
7.
Replace the motor filter for
each tenth time the dust
collector filter is replaced.
Attach the filter with the
cut-off corners facing to
the right.
8.
Replace the dust collector.
9.
Replace the lid, and ...
10.
... push down on the lid. If
the lid cannot be properly
closed, the dust collector is
most likely set incorrectly.
1.
Check the roller each time
the dust collector is
emptied. Begin by lifting
Trilobite by the handle.
2.
Turn Trilobite upside down
and put it on a soft surface
with the display facing you.
3.
Push the locking knob to
the right.
4.
Raise the cover.
5.
Lift the roller by the end
without a drive belt.
Remove it by holding it
at an angle and pulling
upwards/outwards.
6.
Clean the roller. Use a pair
of scissors to cut away
strings, threads, etc.
NOTE! Do not wash the
roller in water or other liquids.
7.
Slide in the roller, take care
to secure the belt and rotate
it so that the teeth engage
securely
.
8.
Press the roller
downwards/inwards.
9.
Replace the lid. When the
three pegs in the picture are
placed correctly, the lid is in
the correct position.
10.
Finally push down the lid
in place.