Fig.5 fig.4, Maintenance, Operation (fig.5) – Sealey ER1700PD User Manual
Page 3
6. MAINTENANCE
WARNING! Before attempting any maintenance ensure the unit is
unplugged from the mains power supply.
6.1.
Keep the machine clean and dry. Do not use abrasives to clean the unit.
Ensure all external head screws are tight.
6.2.
Clean regularly by blowing a jet of compressed air through side vents
to ensure motor ventilation is kept clear.
WARNING! Wear approved safety eye protection and, if necessary,
respiratory protection.
5. OPERATION (FIG.5)
WARNING! The warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and situations
that may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must
be applied by the operator.
fig.5
fig.4
5.1.
Once connected to electrical supply, move the on/off switch
to the 'I' position.
5.1.1.
At this point at this point, the speed indicator will show '00'.
5.1.2.
To start the machine, press the '+' button; the polisher will run at
1000rpm. Each subsequent press will increase the speed by 500rpm
up to a maximum of 3000rpm.
5.1.3.
The speed indication needs to be multiplied by 100 to find the actual
speed.
NOTE: Each time the machine is switched off, the speed setting will
revert to zero.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
WEEE Regulations
Dispose of this product at the end of its working life in compliance with the EU Directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
ER1700PD Issue:1 - 15/10/14
Original Language Version
© Jack Sealey Limited
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.