Sealey CP1440 - Manual (Page 3)

Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycle centre and disposed of in a manner which is compatible with the environment.
When the product is no longer required, it must be disposed of in an environmentally protective way.
Rechargeable battery contains nickel cadmium (NiCad). It is recyclable. Take to your local recycling centre to be
disposed of properly. Do not incinerate NiCad battery as it may explode when exposed to fire.
Do not attempt to open battery pack.
4. MAINTENANCE
4.1 CLEANING
Keep the outer case of the wrench clean and free from grease. DO NOT wash with water or use solvents or abrasives. Use a slightly
dampened cloth. For any other service or maintenance, contact your authorised service agent.
 WARNING! Ensure you read, understand and apply safety instructions before use.
3.2 USING THE WRENCH
3.2.1 Use only impact sockets which are specifically designed for use with an impact wrench. The use of normal chrome vanadium sockets
is dangerous since these are more brittle and are liable to shatter.
3.2.2 Fit the socket to the wrench by snapping it onto the square drive (fig 1.1).
3.2.3 Fit the battery pack to the wrench by aligning the tongue on the battery with the groove in the housing and slide into place. Ensure
that the battery pack is firmly located, you will hear an audible click when it has locked into position.
3.2.4 Select the required direction of rotation. To change direction, push switch (fig.1.2) to the left or right. Familiarise yourself with this
operation before use. DO NOT attempt to change the direction of rotation whilst trigger (fig.1.5) is depressed.
When the wrench is not in use, use the same switch to lock off the trigger by placing the switch in the middle position.
3.2.5 When tightening, release the trigger as soon as the impact sound is heard. Take care not to over-torque small fixings.
Note: Speed of wrench is controlled by trigger depression.
Note: On critical fixings always check the torque with a torque wrench according to the product or vehicle manufacturer’s
guidelines.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Original Language Version CP1440 Issue: 5(L) - 20/04/15
SET BUTTON
CHARGING LEDs
fig. 2
3.1.5 When the charge is complete the red LED will go out and the green LED will
light to indicate charging is complete. The battery pack is now ready for use.
Note: The first charge and several subsequent charges will take longer than usual until
the battery reaches optimum performance, after that the usual charge time will take
approximately 1 hour.
3.1.6 After removing the battery, disconnect the charger from the mains supply and
store in the carry case.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
© Jack Sealey Limited