Sealey BBQ07 - Manual (Page 4)

Original Language Version
BBQ07 Issue: 1 - 05/01/15 © Jack Sealey Limited
Problem Possible Cause Solution
Burner will not light using the ignition system. Gas cylinder is empty. Replace with full cylinder.
Faulty regulator. Have regulator checked or replace.
Obstructions in burner. Clean burner.
Obstructions in venturi. Clean venturi.
Wire is loose or disconnected on Reconnect wire.
electrode or ignition unit.
Electrode or wire is damaged or faulty Change electrode or wire or change igniter.
push button igniter.
The distance between the burner and the Check and ensure the distance between the
electrode pin is too large or too small. burner and the electrode pin is 5-8mm.
Burner will not light using a match. Gas cylinder is empty. Replace with full cylinder.
Faulty regulator. Have regulator checked or replace.
Obstructions in burner. Clean burner.
Obstructions in venturi. Clean venturi.
Irregular heat pattern. Obstructions in burner. Clean burner.
Obstructions in venturi. Clean venuri.
Windy conditions. Use barbecue in a more sheltered position.
New burner may have residual oils Burn grille for 15 minutes with the lid closed.
from manufacturing preocess.
Flare up. Grease build up. Clean grille.
Excessive cooking temperature. Adjust (lower) the temperature accordingly.
Sudden drop in gas flow or heat. Gust of wind. Turn off barbecue, move to new location.
Low on propane. Replace cylinder.
Persistant grease flaming. Grease trapped by food build up around Turn off barbecue, disconnect propane
burner system cylinder, remove food, close hood and allow
the fire to burn out. Remain in attendance.
When extinguished and cool, clean all parts.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
W e b
email
7.1. CLEANING INSTRUCTIONS
7.1.1. To clean the barbecue, turn the burner on for 5 to 10 minutes. Grease will be burned off from the grille.
7.1.2. Ensure the barbecue is cold before continuing. The grille should be cleaned periodically by soaking and washing in soapy water. Use a
wire brush, steel wool or a scouring pad to remove stubborn spots. Alway rinse thoroughly with clean water.
7.1.3. The interior surfaces of the grill housing cover should be washed with hot soapy water.
7.1.4. Regularly clean the drip tray reservoir with hot soapy water. It is sited beneath the barbecue burners and will be hot whilst the
barbecue is in use (fig.1).
7.1.5. Periodically check the burner to see that it is free from insects and spiders which may block the gas system (fig.6).
7.1.6. Clean the venturi tube (fig.6) on the burner very carefully, checking to see that it is free of obstructions. We recommend the use of a
pipe cleaner to clean the venturi tube area.
7.1.7. Any modifications of this appliance may be dangerous and is not permitted. DO NOT alter parts sealed by the manufacturer.
7.2 STORAGE
7.2.1. The gas bottle must be stored outdoors in a well ventilated area and must be disconnected from your barbecue when not being used.
7.2.2. Ensure that you are outside and well away from any sources of ignition before disconnecting your bottle.
7.2.3. When using your barbecue after a period of storage, check for gas leaks and for any obstructions in the burner before using. Also
follow the cleaning instructions to ensure the barbecue is safe. Check that areas under the lid including the burner are free from any
obstruction, (insects, ingress etc.). This area must be kept clean, as it may affect the flow of combustion or air.
7.2.4. We recommend you store the barbecue inside. If stored outside use a barbecue cover to protect this item when not in use. Ensure it is
cool before the cover is used. Covers must be removed periodically to minimise moisture build up.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Environmental Protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or phone 01284 757500.
7. TROUBLESHOOTING