Sealey SSA2 - Manual (Page 2)

3. CONTENTS
3.1 Broadcast Lance and Fixings
4. ASSEMBLY
fig.1
fig.3
4.1 Attach Broadcast Bracket to Tank (see fig.1)
4.1.1 Ensure the bracket is fixed with the two clips at the end
facing the pump.
4.3 Assemble Broadcast Kit. (see fig.3)
4.3.1 Insert the broadcast lance into the bracket, note the
orientation in fig.3.
4.3.2 slide two hose clamps over the hose.
4.3.3 Push the hose onto the hose barb on the broadcast lance
and onto the connector on the pump.
4.3.4 slide the hose clamp around the hose barbs and tighten.
4.2 Remove Spot Sprayer Hose from Pump (see fig.2)
4.2.1 Loosen the hose clamp connecting the hose to the pump.
4.2.2 Pull the hose off of the pump.
fig.2
5.1 Broadcast Lance
5.1.1 Move the broadcast lance into the broadcast position (fig.3).
5.1.2 Ensure the broadcast lance valve is in the oFF position
(fig.4).
5. USE - BROAdCAST SPRAYER
fig.4
Original Language Version ssA2 Issue:2(P)- 18/07/13
NOTE! Refer to the manual for SS37 for the rest of the assembly
procedure and preparation.