Electrolux U31180 EFC 9670-6670 - Manual (Page 13)

electrolux electrolux electrolux electrolux electrolux control panel 13 13 13 13 13
GB
Gr Gr Gr Gr Grease and char ease and char ease and char ease and char ease and charcoal filter coal filter coal filter coal filter coal filter
maintenance indicator maintenance indicator maintenance indicator maintenance indicator maintenance indicator
This hood is fitted with a device that
indicates when it is necessary to clean
the grease filter or the charcoal filter (if
the hood is used in the recirculation
version with a charcoal filter).
On delivery, the hood is not supplied
with a charcoal filter, so the saturation
indicator will be disabled.
If the hood is to be used with a
charcoal filter, the saturation
indicator light must be enabled as
follows:
Set in "OFF
OFF OFF OFF OFF" the hood.
Press buttons 3 3 3 3 3 and 4 4 4 4 4 simultaneously
and hold them for 3 seconds. At first
only the grease filter LED F
F F F F will light up,
but when the charcoal filter LED C C C C C
lights up the saturation indicator will be
enabled.
To disable it: Press buttons 3
3 3 3 3 and 4 4 4 4 4
again simultaneously and hold
them for 3 seconds, until the charcoal
filter LED goes out.
Grease filter LED (F)
LED F
F F F F will start to flash when it is time
to clean the grease filter.
Cleaning will be necessary after 40
working hours. Always comply with the
maintenance instructions for the grease
filter.
Charcoal filter LED (C)
The charcoal filter LED C
C C C C will start to
flash when the charcoal filter needs to
be replaced.
This operation is necessary after
approximately 160 working hours.
Resetting the saturation indicator
After cleaning or replacing the filters,
press button 3
3 3 3 3 for 3 seconds until the
grease filter LED F F F F F or the charcoal filter
LED C C C C C stops flashing.