Euro-Pro V1055H - Manual (Page 3)

PROBLEM SOLVING PRECAUTIONARY MEASURES
This appliance was inspected thoroughly and was in good operating condition when it
was shipped from the factory. If a minor problem occurs, it usually can be solved quite
easily when the cause is found. Therefore, this checklist is provided for your
convenience.
Important: If the suction opening in the unit, the hose or the extension tube become
blocked, switch off the vacuum cleaner and remove the blocking
substance before you start the unit again.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Cleaner Won’t
Run
1. Not properly plugged into wall
outlet.
2. No electricity in wall outlet.
3. On/Off switch not turned on.
4. Motor thermostat tripped.
5. Blown fuse/tripped breaker.
1. Plug in firmly.
2. Check fuse or breaker.
3. Push on/off switch to on
4. Reset motor thermostat.
5. Reset circuit breaker or
replace fuse.
Cleaner Won't
Pick Up
1. Full or clogged dust cup.
2. Wrong pile height setting.
3. Clogged nozzle.
4. Clogged dust inlet port.
5. Clogged hose.
6. Broken belt.
7. Hose not inserted fully.
8. Dirty filters.
9. HEPA Type filter and filter ring
needs cleaning or replacing.
1. Clean dust cup (container).
2. Adjust setting.
3. Remove obstruction.
4. Remove power head cover
and remove obstruction.
5. Remove obstruction.
6. Replace belt.
7. Push hose in securely.
8. Clean / change filters.
9. Clean or replace HEPA Type
filter and filter ring.
Cleaner Picks
Up Moveable
Rugs Or Pushes
Too Hard
1. Wrong pile height setting. 1. Adjust setting.
Agitator Does
Not Turn
1. Broken belt.
2. Belt installed incorrectly.
1. Replace belt.
2. Check belt changing and
agitator cleaning.
Air Flow
Restricted With
Attachment Use
Sound Changes
1. Attachment use restricts air
flow.
2. New carpet debris clogging air
path.
1. Check attachment.
2. Remove obstruction.
1. Do not operate the vacuum cleaner
too close to heaters, or radiators. 5. When pulling out the power plug
from the wall outlet, pull the plug
not the power cord.
6. Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.
2. Before inserting the power plug
into the wall outlet, make sure that
your hands are dry.
7. Do not run appliance over power
cord.
8. Do not use without dust cup
(container) or filters in place.
9. Before you start vacuuming,
make sure to remove large or
sharp objects that might
damage the vacuum.
3. Do not vacuum any liquids.
Note: This vacuum cleaner is equipped
with a plug and power cord that retract
automatically. If the cord or plug get
damaged, it must be replaced by a
qualified technician.
Warning: Hold the plug when
rewinding the cord. Do not allow the
cord to whip when rewinding. 4. Keep hair, loose clothing, fingers,
feet and all parts of body away from
openings, rotating agitator and other
moving parts.
9 2