Rocktrail Z29592 - Manual (Page 25)

25 GB
j Press the ALTI / BARO button 3 until TrK appears in
the display 5 .
j Hold the RESET button 1 down until the altimeter
display indicates 0.
j Press the ST. / STP. button 4 at the start of your long
walk. The TrK in the display will flash.
j Press the ST. / STP. button 4 again when you get to
the end of your long walk.
j Press the RESET button 1 . The minimum and maximum
values of the height measurement will appear in the
display
5 .
Q
Using the barometer
note: When the air pressure measured is more than
1100 h / Pa, “HI” will appear in the display
5 .
note: When the air pressure measured is less than
300 h / Pa, “LO” will appear in the display
5 .
j Press the ALTI / BARO button 3 as often as necessary
until hPa (hectopascal) or mb (millibar) appear in the
display 5 .
j Press the ST. / STP. button 4 for 2 Seconds to choose
between the units hPa, mb and inHg.