Rocktrail 4 Man Tent T13843 - Manual (Page 3)

3 GB/IE
Illustration A:
1. Place the outer tent
1 flat on the ground.
The holders for the poles 3 4 5 must be
facing upwards.
2. Push the poles marked in different colours
carefully through the holders marked with
the same colour.
Illustration B:
3. For pole
5 , insert the two ends of pole into
the eyelets on the pole 5 sleeves for front
door.
4. Set the tent 1 up and fix the poles to the
ground sleeve of the floor fastening.
Illustration C:
5. Fix one side of the tent in the ground with
the tent pegs 7 . Then take hold of the
other end of the tent and pull it apart in
such a way that the tent is taut.
6. Secure the other side of outer tent 1 by
tensioning the floor fastenings with the tent
pegs
7 .
7. Secure the pole 3 4 to the outer tent 1
by the pole clips 10 .
Illustration D:
8. Now secure the outer tent
1 with the guy
ropes 6 and the tent pegs 7 .
9. Open the sunroof (entrance), roll it and
attach it with the two fasteners.
10. Stretch the tent until taut, pull all of the
corners and guy ropes 6 until they are tight.
Do not over-tighten the guy ropes 6 , if the
strength of the wind increases the attachment
point and seam of the tent might tear.
11. Lay out the detachable groundsheet 8
under the living room, peg down the
groundsheet at the eyelets of corners.
Illustration E:
12. Hang the inner tent
2 into the plastic
“O” rings of the outer tent 1 that are
designated for that purpose, the sequence is
from back to the front.
13. Peg down the 4 corners of groundsheet of
inner tent at the webbing loops provided,
same sequence as the above.
14. In case you need simply hang the separate
partition wall 11 into the plastic “O” rings
of the inner tent 2 that are designated for
that purpose.
§ Taking down the tent
Clean the tent both inside and outside
before you take the tent down. The tent must
be dismantled in the reverse order to the
manner in which it has been erected.
§ Packing the tent together
m
CAUTION! Please ensure that the tent is
completely dry before you pack it together.
Otherwise this may result in stains and
damage to the fabric.
m
CAUTION! The tent pegs 7 and other
individual parts must be packed separately
in the bags provided. Otherwise the tent
pegs
7 might damage the tent.
Always fold the outer tent 1 together in
such a way that the floor of the tent is facing
outwards.
Then fold the inner tent 2 and roll it
together.
Collect all of the parts together carefully
before you pack the tent. You should count
the parts in order to ensure that none of
them have been mislaid or lost.
After the tent has been rolled up, pack it
carefully into the carrying bag.
§ Cleaning and Care
m
CAUTION! Never wash the tent in a
washing machine. Otherwise the product
may lose some of its ability to keep out
water.
m
CAUTION! Never use petrol, solvent or
other cleaning agents. Otherwise there is a
danger of damage to the product.
Condensation can form in all synthetic tents;
you should therefore air the tent as frequently as
possible in order to counteract this.
Remove any dirt from the tent with a soft
sponge and clean water.
86706_13_Rock_EN_04.indb 3 2/25/13 3:18 PM