Playtive Training Balance Bike KB-1566 - Manual (Page 24)

26 GB
Care, storage, maintenance
We recommend thoroughly cleaning the product
with water after use.
IMPORTANT! Clean with water only, never with
harsh cleaning agents. Wipe dry with a cleaning
cloth. Always store the dry and clean product
in a temperate room. Apply a drop of oil to the
bearing bushings on the handlebar and wheels
every 3 months.
Disposal Instructions
Please dispose of packaging and product in
an environmentally friendly manner! Dispose of
product through an approved disposal facility
or through your local council. Please note the
recycling regulations in your area.
3 years warranty
The product was produced with great care and
under constant supervision. You receive a three-
year warranty for this product from the date of
purchase. Please retain your receipt.
The warranty applies only to material and
workmanship and does not apply to misuse or
improper handling. Your statutory rights, espe-
cially the warranty rights, are not affected by this
warranty.
With regard to complaints, please contact the
following service hotline or contact us by e-mail.
Our service employees will advise as to the
subsequent procedure as quickly as possible.
We will be personally available to discuss the
situation with you.
Any repairs under the warranty, statutory gua-
rantees or through goodwill do not extend the
warranty period. This also applies to replaced
and repaired parts. Repairs after the warranty
are subject to a charge.
IAN: 78912
Service Great Britain
Tel.: 0871 5000 720 (£ 0.10/Min.)
E-Mail: [email protected]
Settings
Handlebar height
Please note the maximum extension.
Slide up the cover. Loosen the clamp until you
are able to slide the handlebar up and down
and adjust the handlebar to the correct height.
Tighten the clamp, then slide the cover over the
clamp (Fig. P).
Saddle height
Note:
The seat is at the right height when the
child is able to safely touch the ground
with his/her feet.
Please note the maximum extension.
Slide up the cover. Loosen the nut until you are
able to slide the seat up and down and adjust
the seat to the correct height. Tighten the nut and
slide the cover back down (Fig. Q).
Brake
Brake handle
The maximum distance from the handle to the
brake handle is 60mm. Adjust the distance
between the brake handle (20) and the handle
by adjusting the locking screw (Fig. R).
Brake force
CAUTION!
The brake force must be adjusted so
that the rear wheel runs freely when
the brake lever is released and is
blocked when applied.
Press the brake arm (S1) in the direction of the
arrow. Turn the adjusting and locking nut (S2)
counter clockwise to reduce the braking force,
turn the adjusting and locking nut clockwise to
increase the braking force (Fig. S).