Eureka 670 - Manual (Page 7)

HOW TO USE
The upright vacuum cleaner is designed to be used on multiple types of carpeting. Do
not attempt to use the upright vacuum cleaner on bare floors, as damage to the
floor covering may result. Above the floor cleaning tools are available (optional).
The front of the cleaner has an adjustment that
raises or lowers the cleaner base to match the
type of carpet. With the cleaner cord unplugged,
set the adjustment to lowest setting for maximum
cleaning. If the cleaner is difficult to push, move
adjustment to next highest setting until cleaner
is comfortable to push. The brush roll must reach
the carpet for effective cleaning. Make each adjustment with
cleaner switch off and cord
disconnected from outlet. For
ease in moving the adjustment
knob, place handle in operating
position and tilt cleaner back to
remove weight from front wheels.
7
Cleaner Height Setting
WARNING: Avoid injury. Keep loose clothing, hair, fingers, and all other parts
of body away from any moving part (such as the revolving brush).
Turn off the switch and unplug the cleaner before changing the
cleaner height setting.
Handle Adjustment
With the tip of the foot, press down to
release the handle lock located at the left
rear side of the cleaner. Move the handle
and adjust it to the desired position for (1)
storing upright, (2) operating the cleaner at
a comfortable height for the user, and (3)
cleaning underneath low furniture.
Handle Lock
1. Store
2. Use
3.Clean
Underneath
ON/OFF
Power Switch
The power switch is mounted on the
handle. Push ON (-) or OFF (O).