Eagle Electronics SeaFinder 480DF - Manual (Page 76)

70
2. Press
↓ to
S
ONAR
C
OLOR
M
ODE
| ENT .
3. Press
↓ or ↑ to
Mode Name | ENT .
4. Press EXIT | EXIT to return to the Sonar Page.
Sonar Chart Display Options
The Pages Menu offers four chart display options for dual-frequency
models and three options for single-frequency models. To access them,
press
PAGES |
↓ to
Option Name | EXIT .
Pages Menu showing sonar chart display options
(at left, dual-frequency menu; at right, single-frequency menu).
Full Sonar Chart
This is the default mode used when the unit is turned on for the first
time or when it's reset to the factory defaults.
The bottom signal scrolls across the screen from right to left. Depth
scales on the right side of the screen aid in determining the depth of
targets. The line at the top of the screen represents the surface. The
bottom depth and surface temperature (if equipped with a temperature
sensor or a transducer with a temp sensor built in) show at the top left
corner of the screen.
The FasTrack™ display shows just to the right of the scale. This
changes all echoes into short horizontal bars, replicating a flasher
sonar. The zoom bar on the far right shows the area that's zoomed
when the zoom is in use. (See the Zoom section for more information.)