Envision Peripherals LM914 - Manual (Page 14)

LM914
13
1. Press the MENU-button to activate the OSD window. See figure 5.
2. Press or to select the desired function. See figure 5.
3. Press the MENU-button again to activate the highlighted function.
4. Press or to adjust the selected function.
Note: is used to adjust the function down & is used to adjust the
function up. This is due to the orientation of the adjustment level bar.
5. When the OSD window is active, it shows the input signal timing. The "H"
stands for the horizontal frequency and "V" for the vertical frequency.
6. To exit and save, select the exit function, or leave the monitor alone for 10
seconds. If you want to adjust another function press MENU again and
repeat steps 2-4.
Figure 5 The OSD Message
HOW TO ADJUST A SETTING