Electrolux 40740 - Manual (Page 27)

Operating Instructions
27
Pause function
3 The pause function can only be initiated before the drying section of
the programme I. If the pause function is initiated during the drying
section of the programme I the wash programme is ended.
Using the pause function the dishwasher can be temporarily stopped:
0 1. Press the ON/OFF button. The wash programme will stop.
2. All indicators will go out.
3. After a short time when the wash programme is to continue, press the
ON/OFF button again. The wash programme will continue.
2 The wash programme should not be stopped for a prolonged period or
the cooled water will need to be reheated resulting in increased energy
consumption.
Setting or changing the delay start timer
Using the delay start timer you can opt to set the wash programme to
start in 3, 6 or 9 hours.
0 1. Press the ON/OFF button
M
.
2. Setting the delay start timer:
Press the b button until the indicator next to the number of hours of
delay illuminates.
Changing the delay start timer:
As long as the wash programme has not started, you can still change
the delay start set by pressing the b button. Repeatedly press the b
button until all three of the time indicators are off. The selected wash
programme will begin immediately.
3. Press the button for the required wash programme. The programme
indicator lights up.
4. After the set number of hours the wash programme will begin.
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes
in the upper and/or lower basket, an intelligent electronic system
adjusts the amount of water and the duration of the wash programme
to the number of dishes. By this means it is possible to wash only a few
dishes quickly and economically. At half load (6 place settings), up to
2 litres of water and 0.2 kWh of electricity are saved.