Electrolux HD 8694 - Manual (Page 8)

8
Hood Operation
• Best results are obtained by using a low speed for normal
conditions and high speed when odours are more concentrated.
Turn the hood on a few minutes before you start cooking then you
will get an underpressure in the kitchen. It should be left on after
cooking for about 15 minutes or until all odours have disappeared.
The hood operation may be controlled via the control switches or
with the remote control
The control switches are located on lower side of the chimney.
1 - Hood OFF.
2 - Decreases the speed
3 - Hood ON, Increases the speed
4 - 5’/15’ (minutes) timer
push once for 5’ timer, twice for 15’ timer, 3 times to turn the
timer OFF
5 - Filter reset
6 - Light ON/OFF
F - Saturated filter indicator light
- BUTTON 4: Activates and deactivates the timer. Automatically
turns the appliance off at the speed in operation.
LED on = timer activated - Duration 5 or 15 minutes as set.
- BUTTON 5: Once you have replaced the charcoal filters, press
this button for at least 3 seconds until the light turns off
- BUTTON 4+5: Remote control code programming. Keep both
buttons pressed for at least 3 seconds. A beep will sound to
indicate that the programming mode has been accepted.
Without releasing the buttons, press any one of the remote
control buttons. A beep will sound to indicate that the code has
been accepted and stored.
- F LED: Indicates that the charcoal filter is saturated.
This LED is also ON when the hood is used in the extractor
version, press BUTTON 5 until the light turns off.
1 2 3 4 5 F 6