Use using the string of lights, Changing bulbs – Melinera Z28965-BS User Manual
Page 23
23
GB/MT
The string of lights
1
is protected against splashes of water (IP44) as
long as the socket meets the minimum protection standard.
If in any doubt about the safe installation or use of this product, please
consult a qualified electrician.
Make sure the string of lights
1
is not laid down in areas where lawn
mowers, trimmers, scissors or similar cutting tools are used.
Only use the string of lights
1
if all fittings
6
are equipped with bulbs
7
.
Use
Using the string of lights
CAUTION! The bulbs
7
can become loose during transport. Make sure
before starting that all the bulbs
7
are properly in the fittings
6
.
First fit the decoration
2
on the bulbs
7
(see Fig. A).
CAUTION! RISK OF INJURY! Be very careful when you are doing
this. The bulbs
7
may otherwise be damaged.
Insert the supply line plug into the socket of the power pack
3
. Tighten
the cap nut in clockwise direction.
Push the ground spikes into a suitable surface (lawn, etc.).
Note: Arrange the decorative lights so that the distance between each
ground stake is at least 1.5 m.
Plug the power pack
3
into a suitable socket. The lights are switched on.
To switch the lights off, remove the power pack
3
from the socket.
Changing bulbs
DANGER TO LIFE BY ELECTRIC SHOCK! Always
unplug the power pack
3
from the socket before installation, dismantling,
maintenance or cleaning.
CAUTION! RISK OF BURNS! Allow the string of lights
1
to cool
down completely before changing the bulbs
7
.
First lift the decoration
2
up and off the bulbs
7
(see Fig. A).
CAUTION! RISK OF INJURY! Be very careful when you are doing
this. The bulbs
7
may otherwise be damaged.
Remove the faulty bulb
7
from the fitting
6
by bulb remover
5
(see Fig. B).
Plug a new bulb
4
into the fitting
6
.
CAUTION! Make sure that the type, operating voltage and wattage
are correct. Never use other than the stated bulbs
7
.
CAUTION! The bulbs
7
have a plug-in system. Never screw the bulbs
7
in. This can cause damage.
Note: the bulb
7
will only light up if it is fitted the right way round.
The marks on the bulb
7
and the fitting
6
have to be in line with one
another (see Fig. B). Remove the bulb
7
if it does not light up and
replace it in the opposite direction.
Note: make sure that the wires are pointing upwards and that there is
no foreign matter in the fitting
6
.
Replace the decoration
2
over the bulb
7
(see Fig. A).
CAUTION! RISK OF INJURY! Be very careful when you are doing
this. The bulbs
7
may otherwise be damaged.