Florabest FGPS 1100 B2 - Manual (Page 8)

8
GB
Setting up
• Place the unit on a firm, horizontal,
non-flooding surface.
• If you would like to install the device,
screw it together with the base. A
screw connection with a fastening
plate also prevents the device from slip-
ping.
By doing so, ensure a free access to
the drain screw ( 10).
• Always put up the garden pump at a
point higher than the water surface
you wish to pump water from.
Where this is impossible, install a low
pressure-resistant shut-off implement
between the appliance and the suction
hose (available from specialist retail-
ers).
Mains Connection
The pump you have purchases is already
fitted with an earthed plug. The pump is in-
tended for connection to an earthed socket
at 230 V ~ 50 Hz.
Connecting the hoses
- On the suction side, attach a
hose with reflow stopper and
install a prefilter (available from
specialist retailers).
- On the suction side, do not use
any quick-action connection sys-
tems.
- Do not use the suction hose as a
pressure pipeline.
1. Remove the cover caps (1/3)
from the device.
2. Attach the prefilter with reflow
stopper (15) to the connector
prefilter (16) at the suction hose
device (residual current circuit breaker)
with a rated current of not more than
30 mA; minimum fuse 10 amperes.
• Before each use, check the equipment,
cable and plug for damage. Defective
cables are not to be repaired, but rath-
er replaced by new ones. Have any
damage to your equipment repaired
by a specialist.
• If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent
of the same or a similarly qualified per-
son in order to prevent hazards.
• Do not pull the plug from the socket by
the cable. Protect the cable from heat,
oil and sharp edges.
• Do not carry or fix the equipment by
the cable.
• Use only extension cables that are pro-
tected from spray water and designed
for outdoor use. Always fully unroll a
cable drum before use. Check the ca-
ble for damage.
• Before any work on the equipment,
during work breaks and in the case
of non-use, remove the plug from the
socket.
• The cross-section of mains connection
lines must be no smaller than rub-
ber hose lines with the designation
H07RN-F. The power cable wire cross
section must be at least 2.5 mm 2
Initial Operation
Mount carrying handle
Fix the carrying handle (7) to the
garden pump using the fixing
screws (8).