Garden hose set introduction, Intended use, Parts description – Florabest Garden Hose Set User Manual
Page 14: Technical data, Scope of delivery, Safety information

14 GB
®
Garden Hose Set
Introduction
Congratulations on the purchase of your
new product. You have selected a high
quality product. The assembly and oper-
ating instructions are part of this product. Please read
through all of these instructions and take note of
the advice they contain before starting with assem-
bly. These instructions contain important assembly
and care information. Keep these instructions safe
and if you pass on the product to anyone else please
pass on the documentation as well.
Intended use
This product is suitable as an organizer for the gar-
den. Only for private use. Not for commercial use.
Parts description
1
Spray nozzle
1a
Trigger switch
1b
Adjustment wheel
2
Hose- / tap connector without water stop
3
Hose connector with water stop
4
Screw
5
Rawlplug
6
Hose
7
Hose holder
Technical Data
Hose:
3-ply with mesh
Weight:
approx. 1 kg
Inside diameter:
approx. 9 mm
Outside diameter:
approx. 13.5 mm
Length:
approx. 10 m
Connector:
⅜“
max. operating pressure: 6 bar
Bursting pressure:
18 bar
Hose holder:
Weight:
approx. 0.4 kg
Dimensions:
approx. 19.5 x
23.5 x 13.5 cm
(W x H x D)
Spray nozzle:
Weight:
approx. 185 g
Dimensions:
approx.
21 x 11.5 x 6.3 cm
(W x H x D)
Scope of delivery
1 Spray nozzle
1 Hose- / tap connector without water stop, ½“
1 Hose connector with water stop, ½“
1 Tap connector (¾“) with adapter (½“)
2 Screws
2 Rawlplugs
1 Hose
1 Hose holder
1 Instructions for assembly and use
Safety information
ATTENTION! READ ASSEMBLY- AND OPERAT-
ING INSTRUCTIONS BEFORE USE!
KEEP THE ASSEMBLY AND OPERATING IN-
STRUCTIONS IN A SAFE PLACE!
KEEP OUT OF THE REACH OF
CHILDREN. THIS PRODUCT IS
NOT A TOy! INJURIES MAy
OTHERWISE OCCUR!
This hose is designed for tap water.
Do not drink water from this hose.
Otherwise there is a risk of injury.
Be sure water from the hose cannot return to
the drinking water supply: Disconnect the hose
from the tap after use, or install a backflow pre-
venter or pipe interrupter between the tap and
hose.