Florabest FHa 1100 B2 - Manual (Page 35)

35
GB
Read the sections below to learn more
about each operating element’s function.
Technical Data
Home.water.dispenser..FHA.1100.B2
Mains connection ............230 V~, 50 Hz
Power consumption ............... 1100 Watt
Suction lift ...................................... 7 m
Max. discharge rate ................4.600 l/h
Max. discharge head .................... 45 m
Max. water temperature ................ 35 °C
Hose connection ............................... 1“
Turn-on pressure ..........0,2 MPa (2,0 bar)
Turn-off pressure ........0,45 MPa (4,5 bar)
Maximum pressure ..........1 MPa (10 bar)
Safety class ......................................... I
Degree of protection ........................IPX4
Noise pressure
level (L
pA
) ........74 dB(A); K
pA
= 3,0 dB(A)
Noise performance level
(measured) / (L
WA
)
...............88,2 dB(A ); K
WA
= 2,89 dB(A)
Noise performance level
(guaranteed) ............................. 91 dB(A)
The stated values relate to the use of the
automatic domestic water pump without
automatic switch DSK-19. The values may
differ slightly as a result of use with the au-
tomatic switch.
General Description
Scope of Delivery
- Home water dispenser
- Automatic switch
- Connecting piece
- Carrying handle
- Srews
- Instruction Manual
The diagram of the most impor-
tant functional elements can be
found on the foldout side.
Overview
A
1 Water outlet, automatic switch
2 Protective cap for male thread
3 Protective cap for female thread
4 Water inlet, home water dispens-
er
5 Protective cap for female thread
6 Water outlet, home water dis-
penser
7 On/Off switch
8 Power cable
9 Carrying handle
10 Srews
11 Filler screw
12 Connecting piece
13 Draining screw
14 Protective cap for male thread
15 Water inlet, automatic switch
16 “Alarm” indicator
17 Restart switch
18 “Pump On” indicator
19 “Power On” indicator
20 Automatic switch
Functional description
The home water dispenser pumps water
automatically. The pump will turn on and
convey water at turn-on pressure. The turn-
on point is set in the factory and cannot be
adjusted by the user.