beautypg.com

Florabest FKS 2200 B1 User Manual

Page 17

background image

17

GB

edge of the bar towards the first

cut to prevent the bar from becom-

ing jammed in the wood.

M

3.. Log.is.supported.at.both.

ends:

Start from the top and work down

(with the lower edge of the bar)

to a third of the diameter of the

trunk. Then saw from underneath

with the upper edge of the bar

until the two cuts meet.

N

.4.. Sawing.on.a.sawhorse:

Hold the electric chainsaw steady

with both hands, keeping the

saw in front of you while saw-

ing. Once the saw is through the

wood, guide the machine passed

you on the right (1). Hold your left

arm as straight as you can (2).

Watch out for the falling trunk.

Position yourself to prevent any

danger from the separated trunk.

Watch your feet. The trunk may

cause injuries when falling. Keep

your balance (3).

O

Limbing

Limbing is the designation for the sawing off

of branches and boughs from a felled tree.

. Many.accidents.occur.dur-

ing.the.removal.of.branches..

Never.cut.tree.limbs.when.

you.are.standing.on.the.log..

Keep.the.spring-back.area.in.

mind.if.branches.are.under.

tension.

• Do not remove support branches until

after the sawing off.

• Branches under tension must be sawed

from below to above, in order to pre-

vent jamming of the chainsaw.

When working on thicker branches, use

the same technique as when you are

sawing up a felled trunk.

• Work to the left of the log and as near

as possible to the electric chainsaw. As

far as possible, the weight of the saw

should rest on the log.

• Change position to saw off branches

on the other side of the trunk.

• Branches sticking out are cut off sepa-

rately.

Felling trees

. A.lot.of.experience.is.nec-

essary.in.felling.trees..Cut.

down.trees.only.when.you.

can.safely.handle.the.electric.

chainsaw..In.no.case.should.

you.use.the.electric.chainsaw.

if.you.feel.unsure.about.any-

thing.

• Ensure that no people or animals are

in the field of action. The safety dis-

tance between the tree to be felled and

the nearest-located workplace must be

2 ½ tree lengths.

• Note the felling direction:

The user must be able to move safely

near the felled tree, to saw off the tree

easily and remove branches.It is to be

avoided that the felled tree snags itself

on another tree. Note the natural fell-

ing direction, which is dependent on

the slope and curvature characteristic

of the tree, wind direction and the

number of branches.

• In the case of sloping ground, stand

above the tree to be felled.