EdgeStar MINI KEGERATOR TBC50S - Manual (Page 9)

EdgeStar Mini Kegerator 6
Non-pressurized Accessory Kit Part Descriptions
The following section describes the parts of the optional TBC50-ACC
Accessory Kit (sold separately) and their purposes.
1. Non-Pressurized Tap - Using a piercing tube, this tap is to be inserted
into a non-pressurized keg. Beer and CO
2
lines are located at the top. It is
good practice to wet the piercing tube to lubricate before tapping the mini-
keg. Once the mini-keg has been tapped, secure the tap assembly onto
the top of the mini-keg using the spring-loaded catch.
2. Cartridge Stand - Used to elevate the cartridge holder and regulator to
fit in the unit's side compartment.
3. Cleaning Bottle - Used with non-pressurized tap assembly and CO
2
to
flush out the beer lines with cleaning solution (see pg. 11). EdgeStar
recommends using the cleaning bottle that came with your mini-kegerator
to conserve CO
2
.
4. CO
2
Cartridge - 16g food grade CO
2
cartridges. This provides the
propellant necessary to pressurize your mini-keg. Do not use BB
gun/paintball CO
2
cartridges - These often have some oil mixed in with
the CO
2
.
5. Regulator - Used to increase/decrease the flow of CO
2
. Please
reference the chart on pg. 11 of your TBC50 manual for pressure
suggestions.
6. Rubber Ring - When tapping your non-pressurized keg, you will need
to insert the tap into this ring and then into the keg. This will prevent CO
2
from escaping the tap set up.
7. CO
2
Releaser - Used to depressurize kegs. (Note: You may not need
to depressurize certain kegs. Please follow keg instructions.)
8. CO
2
Adapter - Screws into cartridge holder and pierces cartridge.
Once the adapter is screwed in, do not unscrew until the CO
2
cartridge is
completely empty, otherwise it will leak out.
9. CO
2
Cartridge Holder - Holds CO
2
cartridge in place so that it can be
pierced by CO
2
adapter. The holder sits in the cartridge stand.
The accessory kit is not a toy. Keep out of the reach of
children. CO
2
Cartridges are under pressure. ANY MISUSE
MAY CAUSE SERIOUS INJURY. DO NOT over-tighten the CO
2
components. DO NOT discharge CO2 cartridges towards face
or body or place them near heat.
WARNING
2
1
3
4
5
6 7
8
9