EdgeStar MINI KEGERATOR TBC50S - Manual (Page 13)

EdgeStar Mini Kegerator 10
Removing the CO
2
line and mini keg
Once your mini keg is consumed, you need to shut off the CO
2
and
remove the keg.
 Open the compartment located on the right-hand side of the mini
kegerator.
 Shut off the regulator (turn the knob counter-clockwise).
 Put a container under the dispenser and pour off any remaining
beer (this will also relieve some of the pressure in the mini keg).
 Open the mini kegerator main door and disconnect the CO
2
line
and beer line.
 Empty the remaining CO
2
from the mini keg with the CO
2
releaser
as shown:
 Undo the tap from the mini keg by releasing the catch (on the top
of the tap) and pulling it up and out of the mini keg):
 Rinse the tap out under running water. You should also clean it
with a mild detergent solution and rinse it thoroughly.
 Clean the lines as directed in the under “Cleaning and
Maintenance” section.
Note that the optional accessories include a cleaning kit that uses CO
2
pressure to force the cleaning solution through the lines. To use this
system, fill the cleaning kit half full with your choice of cleaning solution
(water mixed with a bit of beer line cleaner, baking soda, or white
vinegar), connect it to the unit as if it were a non-pressurized mini keg,
and pour out all of the solution. Make sure to rinse the lines again!