Echo SRM - 410U - Manual (Page 24)

24
fuel fIlter
Level 1.
Tools required: 200- 250 mm (8 - 10 in.) length of wire with one end
bent into a hook, clean rag, funnel, and an approved
fuel container.
Parts required: REPOWER TM Tune-Up Kit
DANGER
Fuel is VERY flammable. Use extreme care when mixing, storing or
handling.
1. Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2. Use the “fuel line hook” to pull the fuel line and filter from the
tank.
3. Remove the filter from the line and install the new filter.
spark plug
Level 2.
Tools Required: T-wrench, feeler gauge, soft metal brush.
Parts Required: REPOWER TM Tune-Up Kit
1. Remove spark plug and check for fouling, worn and rounded
center electrode.
2. Clean the plug or replace with a new one. DO NOT sand blast to
clean. Remaining sand will damage engine.
3. Adjust spark plug gap by bending outer electrode.
4. Install Spark Plug, and tighten to 150-170 kgf • cm
(130-150 in. • lbf).
0.6 - 0.7 mm (.024 - .028 in)