Crivit SP - 33 - Manual (Page 5)

EN
g
LI
sH
EN
g
LI
sH
Press x1: continuous light, press x2: flashing light,
press x3: colour chaser, press x4: light off.
4. CHaNgINg THE BaTTErIEs
The LED tail light comes equipped with a CR 2925 (3V) battery. To
change this battery, unscrew the four screws on the reverse of the light
with a small screwdriver. Then lift the cover, exchange the batteries and
put the cover back on. Now fasten the cover again with the four screws
(Fig. 4).
Battery-type: Cr 2025 (3v)
5. CLEaNINg aND CarE
The housing of the LED rear light can be cleaned with a damp cloth.
usEr INForMaTIoN
1. BEForE THE FIrsT usE
Take the tail light off the helmet
(fig. 2a). Before the first use,
remove the safety strips from
the reverse of the LED tail light.
(Fig. 1).
2. rEMovaL aND aTTaCHMENT oF THE TaIL LIgHT
To remove the LED tail light, push this upwards out of the holder (Fig. 2a).
To attach the LED tail light, push this again into the holder provided
(Fig. 2b).
3. FuNCTIoNs
The LED rear light has three different functions, each of which can be
used as desired (Fig. 3).
Fig. 1
Fig. 2a
Fig. 3
1x
Fig. 4
Fig. 2b
2x 3x