Crivit SP - 33 - Manual (Page 4)

6
Bicycle helmet SP - 33
3. Adjusting the strap divider
• Open the strap divider (Fig. D)
• The strap divider must be positioned in such a way, that the straps are taut but comfor-
table. The strap divider must be below the ear, and the straps must not cover the ears.
• Close the strap divider (Fig. E)
An open strap divider can lead to slipping of the helmet in the event
of an accident and thus to a loss of protection!!!
4. Adjusting the chin strap
• The chin strap (Fig. G.3) has been adjusted correctly if you feel slight pressure when
you open your mouth.
• If the chin strap (Fig. G.3) is too loose it must be pulled tight using the winding (Fig.
G.2) on the fastener (Fig. G.1).
• If the chin strap (Fig. G.3) is too tight it must be loosened also using the winding (Fig.
G.2) on the fastener (Fig. G.1).
Please note that you must always make sure that the fastener is
closed before you ride !!! (Fig. F)
Please be aware that the helmet can only protect if it fits properly.
Please try out different sizes and choose the one in which the helmet
fits comfortably and sits firmly upon your head.
5. Visor
• Carefully pull out the pins on the visor from the pin holes on the helmet shell to remo-
ve the visor (Fig. H).
Attention: The pin holes on the helmet can expand through excessive
use. In this case, the visor may no longer be used.
6. Cleaning and care
• All chemicals, paints and stickers can seriously impair the protective effect of the
helmet.
• Only clean your helmet with lukewarm water, mild soap and a soft cloth.
• After every use, leave your helmet exposed to the air in order for it to dry.
7. Disposal
Please contact your local waste disposal company for the disposal of the helmet.
130124_4+5-14_ LB04_GA.indd 6 08.03.2013 11:36:23