Kichler 300123 - Manual (Page 8)

7
Fig. 13
Step 1. Tuck all the connections neatly into the
ceiling outlet box.
Step 2. Slide the canopy up to ceiling and over
the two screws on the ceiling mounting
bracket. Rotate canopy clockwise, next, while
holding the canopy with one hand, slide the
canopy cover over the screws and rotate
clockwise until tight.
NOTE: Adjust the canopy
screws as necessary until the canopy and
canopy cover are snug. (Fig.13)
8. FINISHING THE INSTALLATION
Outlet box
Ceiling
mounting
bracket
Canopy
Canopy cover
Screws
9. ATTACHING THE FAN BLADES
Fig. 14
Step 1. Attach a blade to a blade bracket
using the screws, metal washers and fiber
washers provided. (Fig. 14)
Make sure the blade is straight when set on
the blade bracket. Tighten each mounting
screw and then repeat this procedure for each
blade.
Step 2. Attach each blade assembly to the
motor using the "Pre-Installed" mounting
screws in the blade bracket. (Fig. 14)
Screws
Washers
Blades
blade brackets
Screws
Fiber
washers