Al390kcl-339011 p5, Close-to-ceiling installation – Kichler 337014 v.1 User Manual
Page 6

5
Fig. 10
Fig. 9
Fig. 8
Registration slot
Check tab
Canopy
Rubber gasket
Screws and Lock washers
(3 of 6 places)
Coupling
Hook
Step 3. Carefully feed the electrical lead wires
from the fan up through the downrod. Thread
the downrod into the coupling until the Hitch
pin holes are aligned.
Next, replace the hitch pin and retaining clip.
Tighten both set screws. (Fig. 7)
Step 4. Slip the coupling cover, canopy cover,
decorative mounting screw cover and canopy
onto the downrod.
Thread the hanger ball onto the downrod,
insert the cross pin through the downrod and
tighten. Now tighten the set screw. (Fig. 7)
Step 5. Lift the motor assembly into position
and place the hanger ball into the ceiling
mounting bracket.
Rotate the entire assembly until the "Check
Tab" has dropped into the "Registration Slot"
and seats firmly. (Fig. 8)
The entire motor assembly should not rotate
(left or right) when seated properly.
WARNING: Failure to reattach the cross pin
and seat the "Check Tab" can cause the fan to
fall from the ceiling during operation. Take
special care to make sure this pin is
reattached.
Step 1. Remove three of the six screws and
lock washers (every other one) from the
coupling on top of the motor assembly. Place
the ceiling fan canopy and the rubber gasket
over the collar and align the mounting holes
with the holes in the coupling. Attach the
canopy with the rubber gasket and the three
screws and lock washers previously removed.
(Fig. 9)
WARNING: Failure to completely tighten the
three mounting screws in step 9 could result in
the fan possibly falling from the ceiling.
Step 2. Hang the fan on the ceiling mounting
bracket by inserting the hook on the inside
edge of the ceiling mounting bracket through
one of the screw holes in the ceiling canopy
(Fig. 10). This will allow you to have both
hands free to make the wiring connections.
CLOSE-TO-CEILING INSTALLATION