beautypg.com

Al390kcl-339011 p4, 42" sutter place, Select – Kichler 337014 v.1 User Manual

Page 5: Hanging the fan standard ceiling installation

background image

4

Fig. 7

Mounting screws
(supplied with
electrical box)

Hook

Ceiling
mounting
bracket

UL Listed
outlet box

120V Wires

Washers

Fig. 6

Supply wires

Downrod

Retaining pin

Hitch pin

Set screws

Coupling

Set screws

Canopy

Coupling cover

Cross pin

Hanger ball

Set screw

NOTE: This ceiling fan is supplied with two
types of hanging assemblies; a downrod and
canopy mounting system and a "close to ceiling"
Canopy ONLY system. The "close-to- ceiling"
installation is recommended in rooms with less
than 8-foot ceilings or in areas where additional
space is desired from the floor to the fan blades.
Once you have selected which mounting system
you will use, proceed with the following
instructions. Where necessary, each section of
the instructions will note the different procedures
to follow for the two types of mounting.

REMEMBER

to turn off the power before you

begin.
To properly install your ceiling fan, follow the
steps below.

Step 1. Remove the decorative canopy bottom
cover from the canopy. (Fig. 5)

Step 2. Loosen the four screws on the top of the
canopy. Remove the two non-slotted screws
and loosen the slotted screws. This will enable
you to remove the ceiling mounting bracket.
(Fig. 5)

Step 3. Remove the ceiling mounting bracket
from the canopy by loosening the two screws on
the bottom of the ceiling mounting bracket. Turn
the canopy counterclockwise and remove. (Fig. 5)

Step 4. Pass the 120 volt supply wires from the
ceiling outlet box through the center of the
ceiling mounting bracket. (Fig. 6)

Step 5. Attach the ceiling mounting bracket to
the outlet box using the screws and washers
included with the outlet box. (Fig. 6)

Step 1. Remove the hanger ball from the
downrod assembly by loosening the set screw,
removing the cross pin and sliding the ball off
the rod. (Fig.7)

Step 2. Loosen the two set screws and remove
the hitch pin and retaining clip from the coupling
on top of the motor assembly. (Fig. 7)

5. HANGING THE FAN

STANDARD CEILING INSTALLATION

Fig. 5

Ceiling mounting
bracket

Canopy

Canopy cover

Screws

Screws

֞၏

42" Sutter Place

TM

Select

This manual is related to the following products: