Kichler 339212 - Manual (Page 11)

Fig. 18
Lamp holder
Glass shade
10
12. INSTALLING THE LAMP AND
GLASS SHADE
1. Install 1, 22 Watt Fluorescent lamp
(included).
Attach the wire connector from the
transformer to the florescent lamp. Now
attach the lamp to the lamp holders applying
even pressure to the lamp at each lamp
holder. The lamp will pop into place.
NOTE: Sometimes it helps to open the lamp
holder by lifting the end. This enlarges the
holder allowing the lamp to pop into place
easier.
2. Remove the decorative nut, glass cap and
metal nut from the light fixture stem. Slip the
beaded pull chain from the switch housing
into the outside hole in the glass shade then
feed the beaded pull chain from the light
fixture stem through the eyelet in the shade.
Now place the glass shade over the light
fixture stem. Secure the shade with a metal
nut (rubber side touching the shade). (Fig. 18)
3. Fit the decorative glass cap onto the light
kit stem and then slip the beaded pull chain
from switch housing through the hole on the
side of the decorative glass cap. Feed the
beaded pull chain from the light kit stem
through the hole in the decorative nut and
thread the decorative nut on securely.
DO
NOT OVER TIGHTEN.
4. Attach two pull chain fobs one to each of
the beaded pull chains. (Fig. 18)
Note: Make sure to leave enough space
between the fan pull chain and the fluorescent
lamp so the chain doesn't rub against any of
the lamp.
Light kit assembly
Decorative glass cap
Metal nut
Beaded pull chain
Lamp
Decorative nut
Saxon TM Select