Kichler 300119 - Manual (Page 9)

8
Windham TM
11. INSTALLING THE LIGHT KIT
Fig. 14
Fig. 15
NOTE: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power
off using the fan switch is not sufficient to
prevent electric shock.
1. While holding the light kit under your fan,
snap together the wire connection plugs .
2. Carefully push all wires back into the
mounting plate, then install the light kit onto
the mounting plate with 3 screws provided. Be
sure to tighten all screws. (Fig. 14)
12. NSTALLING THE LIGHT BULBS &
GLASS SHADE
Light kit
Mounting plate
Screws
Wire connector
1. Install 3, 40W candelabra bulbs (not
included).
2. Remove the decorative nut, glass cap and
metal nut from the light kit. Place glass shade
over the light kit stem, secure with the metal
nut (rubber side on the top), glass cap and
decorative nut. Do not overtighten. (Fig. 15)
3. insert 3 pull chains through the eyelets in
the shade and cap. Secure the glass cap and
decorative nut provided. (Fig. 15)
4. Restore power and your light kit is ready for
operation.
Note: Make sure to leave enough space
between the fan pull chain and the bulbs so
the chain doesn't rub against any of the bulbs.
Light kit
Bulbs
Glass shade
Glass cap
Decorative nut
Metal nut