beautypg.com

Kcl45+1l-310102-e-p12, Harbour walk, Patio – Kichler 310102 User Manual

Page 13: Installing the cooltouch

background image

12

Fig. 24

Fig. 25

15. INSTALLING THE COOLTOUCH

CONTROL SYSTEM WALL PLATE

16. INSTALLING THE TRANSMITTER

1. Insert the transmitter into the wall plate by
inserting the bottom of the transmitter first and
then press the top of the transmitter into the
pocket. The transmitter will fully function from
this location or you can remove the transmitter
and use as a "Hand Held" device. (Fig. 26)

2. To remove the transmitter from the wall
plate, push the release button and the
transmitter will fall into your hand.

Release

button

Fig. 26

Wall plate

Switch

Outlet box

Select a location to install your CoolTouch™
Control System Transmitter. You can replace
an existing wall switch or, install the transmitter
on ANY flat surface.

Option 1: Install the control system using an
existing wall switch outlet box.
Make sure the electrical power is TURNED
OFF at the main panel before continuing.

Step 1. Remove the existing wall plate and the
old switch from the wall outlet box. Wire nut
the BLACK leads (hot) together and push back
inside the outlet box. (Fig. 24)

Step 2. Install the metal plate and CoolTouch™
wall plate to the existing wall outlet box with 4
screws provided. Then place the two plastic
plugs into the wall plate. (Fig. 25)

Option 2: Install the control system on ANY
flat surface.

Select the desired location and use the
CootTouch™ wall plate to mark the location for
the mounting holes.

Plastic wall anchors and screws are provided
for this type of installation.

After installing the wall anchors, attached the
CoolTouch™ wall plate with the mounting
screws and then insert the plastic plugs to
finish the installation.

Screws

Screws

Plastic plugs

CoolTouch

wall plate

Outlet box

Metal plate

Harbour Walk

TM

Patio