Kcl45+1l-310102-e-p9, Installing the light bulbs and glass shade, Installing the light kit – Kichler 310102 User Manual
Page 10

9
Fig. 18
Fig. 19
Step 1. Install 4, 40W T3 halogen bulbs
(provided). (Fig. 19)
Step 2. Remove the 4 screws from the rim of
the light fixture. Raise the glass shade and
decorative frame against the light fixture and
align the screw holes of the light fixture with
the holes of the glass shade and decorative
frame.
Secure by installing the 4 screws and
tightening.
12. INSTALLING THE LIGHT BULBS AND
GLASS SHADE
NOTE: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box.
Step 1. Remove 1 of the 3 screws from the
mounting plate and loosen the other 2 screws
(do not remove). (Fig. 18)
Step 2. Raise and hold the light kit close to the
mounting plate. Connect the white wire
connectors from the light kit and fan. Follow
the same procedure with the black wire
connectors. (Fig. 18)
Step 2. Tuck connections neatly into mounting
plate and then place the light kit key holes over
the 2 screws previously loosened from the
mounting plate, turn light kit until it locks in
place at the narrow section of the key holes.
Secure by tightening the 2 screws previously
loosened and the one previously removed.
(Fig. 18)
11. INSTALLING THE LIGHT KIT
Light plate
Wire connectors
Light fixture
Mounting Screws
Glass shade and
decorative frame
Light fixture
Light plate
Screws
Bulbs